RED ORCHIDEA Instructions d'exploitation Page 31

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 30
red
PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL
page 31
Operation Technical service - Rights reserved - Reproduction prohibited
4.3. MAKING THE ELECTRICAL CONNECTIONS
Connect the supply cable first at the rear of the stove and then to an
electrical outlet on the wall.
The main switch located on the rear of the stove should be switched on
only when you want to light the stove.
If you do not intend to use the stove, it is advisable
to keep it switched off.
4.4. STOVE POWER SUPPLY
Once the power cord is connected to the rear part of the stove, place
the switch, also on the rear, to position (I).
The lighted button of the switch will come on.
The switch located to the rear of the stove powers the system.
On the rear of the stove there is a fuse box which is located
underneath the mains socket. Use a screwdriver to open the fuse box
if necessary replace them (3.15 A delayed).
4.5. PRE-LIGHTING CHECK
Check that all the safety conditions described above have been met.
Make sure you have read and completely understood the contents of
this instruction booklet.
Remove any components which might burn from the firebox and from
the glass (various instructions and adhesive labels).
Check that the grate A is properly positioned and rests correctly on the
base.
After long periods of disuse, remove from the hopper (using
a vacuum cleaner with an extension) any remains of
pellets which have lain there for some time, since they may
have absorbed moisture, which changes their original
characteristics and makes them unsuitable for burning.
4.6. FIRST LIGHTING
4.6.1. Ignition/shutdown using the control panel
(Key D)
The stove is ignited and shutdown by pressing key D on the control
panel for 2 seconds.
When switching on, LED 1 flashes green, whereas when the stove is lit
it is fixed green.
After a start-up phase lasting about 20 minutes, the stove
enters into full working order (led 1 lit with fixed green light).
Key D is also used to switch the stove off (see section.4.8).
Electrical connection of the stove
Vue de la page 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Commentaires sur ces manuels

Pas de commentaire