RED ORCHIDEA Instructions d'exploitation télécharger pdf (Page 28)

red

PELLET STOVES Chapter 4

INSTALLATION AND USE MANUAL

page 28

Operation Technical service - Rights reserved - Reproduction prohibited

4. OPERATION

4.1. PRE-LIGHTING WARNINGS

Do not touch the stove during the first lighting, as it

is during this phase that the paint sets. If you touch

the paint, you may expose the steel surface.

If necessary, touch up the paint with the aerosol spray in the original

colour (see the section "Accessories for pellet stoves").

It is good practice to provide plenty of ventilation in

the room during the initial lighting, as the stove will

give off a small amount of smoke and smell of paint.

Do not stay near the stove, and as previously mentioned, ventilate the

room. The smoke and the smell of paint will vanish after about one

hour of operation. There are no health risks involved.

The stove will be subject to expansion and contraction during the

stages of lighting and cooling down, and may therefore make slight

creaking noises.

This phenomenon is absolutely normal, the structure being made of

sheet steel, and must not be considered a fault.

It is extremely important to be sure not to take the stove to full heat

straight away, but to bring it gradually up to temperature.

If use low heating powers (for example 1

-2

-3

). During subsequent

use, you will be able to make use of all available heating power (e.g.

-5

), but remember not to keep the stove running on full power for

more than 60-90 minutes.

In this way you will avoid damage to the ceramic panels, the welds and

the steel structure.

Do not demand full heating

performance straight away!

Try to get familiar with the commands given from the control panel.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Pas de commentaire

RED ORCHIDEA Instructions d'exploitation Page 28