RED DSMC Manuel de service télécharger pdf (Page 172)

Version 3.0

171

DC IN (POWER INPUT)

The 6-pin LEMO connector accepts a DC voltage between +11.5V and +17V DC. Power conditioning

circuits provide protection against reverse-polarity connection, ESD, under voltage, and over current.

Figure 25: View into camera DC IN Power Input connector

Mating Connector: LEMO FGJ.1B.306.CWLD72Z

PIN SIGNAL DESCRIPTION

+VBATT Power input, +11.5 to +17VDC

3 SCL-BATT Serial Battery Bus Clock

GROUND Power Return (Camera Ground)

6 SCA-BATT Serial Battery Bus Data

WARNING: It is very important that both pairs of +VBATT and GROUND pins are wired up. DO

NOT fabricate power cables with just one each of +VBATT and GROUND pins wired, as this may

cause damage to the camera’s power supply; this is not covered by Warranty.

NOTE: Two pre-fabricated DC Power input cables are available from RED Digital Cinema.

• P/N 790-0138 – DC Power – REDBRICK® to Camera – 18 in. (0.5m)

• P/N 790-0164 – DC Power – XLR to Camera – 10 ft. (3m)

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 238 239

Pas de commentaire

RED DSMC Manuel de service Page 172