RED DSMC Manuel de service télécharger pdf (Page 170)

Version 3.0

169

CTRL (RS232 CONTROL)

A 4-pin LEMO connector supports RS232 remote control for stereoscopic camera image capture, and

third party metadata ingest applications.

The shutter Sync Output signal acts as an immediate response hardware tally of a scan. This is useful

for 3D or motion control applications where a slave camera or lighting device needs to be synchronized

to a master camera.

Alternatively, this output pin may be used as a GPO (General Purpose Output) tally, whose function is

programmed in the USER KEYS menu. Default is Record Tally.

Figure 23: View into camera CTRL (RS232 Control) Interface connector

Mating Connector: LEMO FGG.00.304.CLAD27Z

PIN SIGNAL DESCRIPTION

1 GROUND Common Ground

2 232 RX RS232 RX

3 SS/GPO Shutter Sync / GPO Output

4 232 TX RS232 TX

NOTE: When active, the GPO tally presents 3.3V @ 0.04 Amps maximum between pins 1 and 3.

When used as Sync Out, the signal is rising edge pulse at start of exposure. As a Tally, it is rising

edge at start of record, falling edge at end of record.

NOTE: A pre-fabricated CTRL interface cable is available from RED Digital Cinema.

• P/N 790-0152 – RS232 – Camera to DB-9 – 3 ft. (1m)

• DB-9 Pin 1: Shutter Sync / GPO

• DB-9 Pin 2: RS232 Tx

• DB-9 Pin 3: RS232 Rx

• DB-9 Pin 4: Ground

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 238 239

Pas de commentaire

RED DSMC Manuel de service Page 170