RED COMPACT 18 Guide de l'utilisateur télécharger pdf (Page 19)

Troubleshooting

No Light

This troubleshooting guide is meant to help solve simple problems.

If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit

operates properly, do not carry out following steps.

If the light effect does not operate properly, refer servicing to a technician.

Response: Suspect three potential problem areas: the power supply, the LEDs, the fuse.

1. Power supply. Check that the unit is plugged into an appropriate power supply.

2. The LEDs. Return the Compact Par 18 Tri MKII to your Showtec dealer.

3. The fuse. Replace the fuse. See page 16 for replacing the fuse.

4. If all of the above appears to be O.K., plug the unit in again.

5. If you are unable to determine the cause of the problem, do not open the Compact Par, as this may

damage the unit and the warranty will become void.

6. Return the device to your Showtec dealer.

No Response to DMX

Response: Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card

malfunction.

1. Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.

Try your DMX control again.

2. Determine whether the controller or light effect is at fault. Does the controller operate properly with

other DMX products ? If not, take the controller in for repair. If so, take the DMX cable and the light

effect to a qualified technician.

See next page for more problem solving.

1 2 ... 14 15 16 17 18 19 20 21 22

Pas de commentaire

RED COMPACT 18 Guide de l'utilisateur Page 19